This weeks project was one to free up desk space when I am not using my keyboard for work. I had seen some people in the mechanical keyboard community storing their boards on a SKÅDIS and it inspired me to create this solution to store my Apple Magic keyboard and Magic Trackpad when not in use.
I designed the holder to fit with tight tolerances all around. The lip that holds the keyboard is small so that it just holds the keyboard and does not press any keys. Also, the clip that goes into the SKÅDIS pegboard is a tight fit.
These print with no support.  With that I modeled only one side. Before slicing, I would recommend mirroring one of the two parts needed over the x axis for better symmetry. 

A word of caution: Do be careful to not knock or strike the SKÅDIS too hard while the keyboard is on it. The SKÅDIS board can be springy so it may cause the keyboard to fall off.

You can find the files on Printables at the link below. Let me know if you print a pair!

Thanks for reading and good luck with what you create!
Back to Top